ZyXEL Communications VMG3312-T20A - 8.4 The UPnP Screen

Chapter 8 Home Networking
VMG3312-T20A User’s Guide
130
Figure 55 Static DHCP: Static DHCP Configuration/Edit
The following table describes the labels in this screen.
8.4 The UPnP Screen
Universal Plug and Play (UPnP) is a distributed, open networking standard that uses TCP/IP for simple
peer-to-peer network connectivity between devices. A UPnP device can dynamically join a network,
obtain an IP address, convey its capabilities and learn about other devices on the network. In turn, a
device can leave a network smoothly and automatically when it is no longer in use.
See page 124 for more information on UPnP.
Table 32 Static DHCP: Static DHCP Configuration/Edit
LABEL DESCRIPTION
Active Select Enable to activate the connection between the client and the VMG. Otherwise, select
Disable to deactivate.
Group Name Select the interface group name for which you want to configure static DHCP settings. See
Chapter 13 on page 183 for how to create a new interface group.
IP Type This field displays IPv4 for the type of the DHCP IP address. At the time of writing, it is not
allowed to select other type.
Select Device Info Select a device or computer from the drop-down list or select Manual Input to manually enter
a device’s MAC address and IP address in the following fields.
MAC Address If you select Manual Input, enter the MAC address of a computer on your LAN.
IP Address If you select Manual Input, enter the IP address that you want to assign to the computer on
your LAN with the MAC address that you will also specify.
OK
Click OK to save your changes.
Cancel Click Cancel to exit this screen without saving.