Chapter 13 Interface Grouping
VMG3312-T20A User’s Guide
186
13.2.2 Interface Grouping Criteria
Click the Add button in the Interface Grouping Configuration screen to open the following screen.
Figure 101 Interface Grouping Criteria
The following table describes the fields in this screen.
WildCard
Support
This shows if wildcard on DHCP option 60 is enabled.
Modify Click the Edit icon to change the group setting
Click the Delete icon to delete this group from the VMG.
OK Click OK to save your changes.
Cancel Click Cancel to exit this screen without saving.
Table 73 Interface Group Configuration (continued)
LABEL DESCRIPTION
Table 74 Interface Grouping Criteria
LABEL DESCRIPTION
Source MAC
Address
Select this option and enter the source MAC address of the packet.
DHCP Option 60 Select this option and enter the Vendor Class Identifier (Option 60) of the matched traffic, such
as the type of the hardware or firmware.
Enable
wildcard
Select this option to be able to use wildcards in the Vendor Class Identifier configured for DHCP
option 60.
DHCP Option 61 Select this and enter the device identity of the matched traffic.
Enter the Identity Association Identifier (IAID) of the device, for example, the WAN connection
index number.
DHCP Option
125
Select this and enter vendor specific information of the matched traffic.
Enterprise
Number
Enter the vendor’s 32-bit enterprise number registered with the IANA (Internet Assigned Numbers
Authority).
Manufactur
er OUI
Specify the vendor’s OUI (Organization Unique Identifier). It is usually the first three bytes of the
MAC address.
To Next Page
Loading...
