ZyXEL Communications VMG3312-T20A - Page 185

Chapter 13 Interface Grouping
VMG3312-T20A User’s Guide
185
Figure 100 Interface Group Configuration
The following table describes the fields in this screen.
Table 73 Interface Group Configuration
LABEL DESCRIPTION
Group Name Enter a name to identify this group. You can enter up to 30 characters. You can use letters,
numbers, hyphens (-) and underscores (_). Spaces are not allowed.
WAN Interface
used in the
grouping
Select the WAN interface this group uses. The group can have up to one PTM interface, up to
one ATM interface, up to one ETH interface, and up to one WWAN interface.
Selected LAN
Interfaces
Available LAN
Interfaces
Select one or more LAN interfaces (Ethernet LAN, HPNA or wireless LAN) in the Selected LAN
Interfaces list and use the left arrow to move them to the Available LAN Interfaces list to add the
interfaces to this group.
To remove a LAN or wireless LAN interface from the Available LAN Interfaces, use the right-
facing arrow.
Automatically
Add Clients With
the following
DHCP Vendor
IDs
Click Add to identify LAN hosts to add to the interface group by criteria such as the type of the
hardware or firmware. See Section 13.2.2 on page 186 for more information.
# This shows the index number of the rule.
Filter Criteria This shows the filtering criteria. The LAN interface on which the matched traffic is received will
belong to this group automatically.