ZyXEL Communications VMG3312-T20A - 12.3 The Dynamic DNS Screen

Chapter 12 Dynamic DNS Setup
VMG3312-T20A User’s Guide
181
The following table describes the labels in this screen.
12.3 The Dynamic DNS Screen
Use this screen to change your VMG’s DDNS. Click Network Setting > DNS > Dynamic DNS. The screen
appears as shown.
Figure 97 Network Setting > DNS > Dynamic DNS
The following table describes the fields in this screen.
Table 70 DNS Entry: Add/Edit
LABEL DESCRIPTION
Host Name Enter the host name of the DNS entry.
IP Address Enter the IP address of the DNS entry.
OK Click OK to save your changes.
Cancel Click Cancel to exit this screen without saving.
Table 71 Network Setting > DNS > > Dynamic DNS
LABEL DESCRIPTION
Dynamic DNS Setup
Dynamic DNS Select Enable to use dynamic DNS.
Service Provider Select your Dynamic DNS service provider from the drop-down list box.
Host Name Type the domain name assigned to your VMG by your Dynamic DNS provider.
You can specify up to two host names in the field separated by a comma (",").
Username Type your user name.
Password Type the password assigned to you.
Dynamic DNS Status
User
Authentication
Result
This shows Success if the account is correctly set up with the Dynamic DNS provider
account.
Last Updated Time This shows the last time the IP address the Dynamic DNS provider has associated with the
hostname was updated.