Chapter 33 Firmware Upgrade
VMG3312-T20A User’s Guide
247
Figure 151 Firmware Uploading
The VMG automatically restarts in this time causing a temporary network disconnect. In some operating
systems, you may see the following icon on your desktop.
Figure 152 Network Temporarily Disconnected
After two minutes, log in again and check your new firmware version in the Status screen.
If the upload was not successful, the following screen will appear. Click OK to go back to the Firmware
Upgrade screen.
Figure 153 Error Message
Current
Firmware
Version
This is the present Firmware version and the date created.
File Path Type in the location of the file you wasnt to upload in this field or click Choose File to find it.
Choose File Click this to find the .bin file you want to upload. Remember that you must decompress
compressed (.zip) files before you can upload them.
Upload Click this to begin the upload process. This process may take up to two minutes.
Upgrade WWAN
Package
Current
WWAN
Package
Version
This is the present WWAN Package version and the date created.
File Path Type in the location of the file you want to upload in this field or click Choose File to find it.
Choose File Click this to find the .bin file you want to upload. Remember that you must decompress
compressed (.zip) files before you can upload them.
Upload Click this to begin the upload process. This process may take up to two minutes.
Table 118 Maintenance > Firmware Upgrade
LABEL DESCRIPTION
To Next Page
Loading...
