Chapter 5 Wi-Fi
WAH7706 User’s Guide
38
5.5 WPS Screen
Use this screen to configure Wi-Fi Protected Setup (WPS) on your WAH7706.
WPS allows you to quickly set up a wireless network with strong security, without having to
configure security settings manually. Set up each WPS connection between two devices. Both
devices must support WPS. See Section 5.6.5.3 on page 46 for more information about WPS.
Note: To use the WPS feature, make sure you have wireless enabled in the Wi-Fi > Wi-
Fi Settings screen.
Note: If you want to use the WPS feature set the security type to WPA or None.
Click Wi-Fi > WPS. The following screen displays.
Figure 19 Wi-Fi > WPS
The following table describes the labels in this screen.
Action Click Edit to go to the screen where you can edit the rule.
Click Delete to remove the MAC address entry.
Apply Click Apply to save your changes back to the WAH7706.
Reset Click Reset to reload the previous configuration for this screen.
Table 18 Wi-Fi > MAC Filter (continued)
LABEL DESCRIPTION
Table 19 Wi-Fi > WPS
LABEL DESCRIPTION
Select WPS
Interface
Select SSID 1 (or SSID 2) to configure WPS.
Enable Select On to activate WPS on the WAH7706. Otherwise, select Off.
To Next Page
Loading...
