ZyXEL Communications WAH7706 - IPv6 and Port Filtering Rules Setup

Chapter 6 Router
WAH7706 User’s Guide
56
6.7 IPv6/Port Filter Screen
The WAH7706 firewall is a packet filtering firewall and restricts access based on the source/
destination computer network address of a packet and the type of application. Use this screen to
configure IP filtering rules. To access this screen, click Router > Firewall > IPv6/Port Filter.
Figure 31 Router > Firewall > IPv6/Port Filter
The following table describes the labels in this screen.
Port This field displays a single port number of the destination or the starting port number of a
range.
Enter the port number/range of the destination that define the traffic type, for example TCP
port 80 defines web traffic.
Comment Enter descriptions of the rule in this field.
Action Click Edit to go to the screen where you can edit the filtering rule.
Click Delete to remove the filtering rule.
Apply Click this button to save your changes back to the WAH7706.
Reset Click Reset to reload the previous configuration for this screen.
Table 26 Router > Firewall > IPv4/Port Filter
LABEL DESCRIPTION
Table 27 Router > Firewall > IPv6/Port Filter
LABEL DESCRIPTION
IPv6/Port Filter
Enable IPv6/
Port Filter
Select the check box to enable the rule.
IPv6/Port Filter List
Add New Click Add New to create a new rule.
This field displays the rule index number.
Source IP This field displays the source IP addresses to which this rule applies.