WAH7706 User’s Guide
51
CHAPTER 6
Router
6.1 Overview
This chapter describes how you can configure the management IP address, DHCP settings of your
WAH7706, the IP filtering and content filtering settings.
The Internet Protocol (IP) address identifies a device on a network. Every networking device
(including computers, servers, routers, printers, etc.) needs an IP address to communicate across
the network. These networking devices are also known as hosts.
6.1.1 What You Can Do in this Chapter
•Use the LAN IP screen to configure the WAH7706’s LAN IP address (Section 6.2 on page 51).
•Use the DHCP Server screen to enable the DHCP server on the WAH7706 (Section 6.3 on page
52).
•Use the DNS Settings screen to configure the WAH7706’s DNS settings (Section 6.4 on page
54).
•Use the Connected Devices screen to view current clients information (Section 6.5 on page
54).
•Use the IPv4/Port Filter screen to view and configure IPv4/Port filtering rules (Section 6.6 on
page 55).
•Use the IPv6/Port Filter screen to view and configure IPv6/Port filtering rules (Section 6.7 on
page 56).
•Use the URL Filter screen to view and configure content filtering rules (Section 6.8 on page 57).
•Use the IP/Port Forwarding screen to view and configure port forwarding rules (Section 6.9 on
page 58).
6.2 LAN IP Screen
Use this screen to view or configure the management IP address for your WAH7706. To access this
screen, click Router > LAN IP.
Note: If you change the WAH7706’s IP address, you need to use the new IP address to
access the WAH7706’s web configurator.
To Next Page
Loading...
