ZyXEL Communications WAH7706 - Page 53

Chapter 6 Router
WAH7706 User’s Guide
53
Figure 27 Router > DHCP Server
The following table describes the labels in this screen.
Table 23 Router > DHCP Server
LABEL DESCRIPTION
DHCP Settings
Enable DHCP Server Select the check box to enable the DHCP server on the WAH7706.
Start IP The WAH7706 is pre-configured with a pool of 100 IP addresses starting from
192.168.0.100 to 192.168.0.199.
This field specifies the first of the contiguous addresses in the IP address pool.
End IP This field specifies the last of the contiguous addresses in the IP address pool.
Lease Time
(minutes)
Specify how long (in minutes) each computer can use the information (especially the IP
address) before it has to request the information again.
Static DHCP List
Add New Click Add New to create a new entry.
This field displays the index number of the static IP address entry.
IP Address This field displays the IP address that the WAH7706 assigns to a device with the entry’s
MAC address.
MAC Address This field displays the MAC address of the device to which the WAH7706 assigns the
entry’s IP address.
Action Click Edit to go to the screen where you can edit the static IP address.
Click Delete to remove the static IP address entry.
Apply Click this button to save your changes back to the WAH7706.
Reset Click Reset to reload the previous configuration for this screen.