Chapter 1 Introduction
WRE6505 User’s Guide
10
Wi-Fi 2.4G The device uses two LEDs to generate the following three signal colors:
• Red: signifies a signal strength under 50%
• Orange: signifies a signal strength under 75%
• Green: signifies a signal strength over 75%
Repeater mode
On WLAN signal detected.
Blinking The WRE6505 is sending/receiving data through the wireless LAN.
Off The wireless LAN is not ready or fault detected.
AP mode
On WLAN is powered on.
Blinking The WRE6505 is sending/receiving data through the wireless LAN.
Off WLAN is off.
Wi-Fi 5G The device uses two LEDs to generate the following three signal colors:
• Red: signifies a signal strength under 50%
• Orange: signifies a signal strength under 75%
• Green: signifies a signal strength over 75%
Repeater mode
On WLAN signal detected.
Blinking The WRE6505 is sending/receiving data through the wireless LAN.
Off The wireless LAN is not ready or fault detected.
AP mode
On WLAN is powered on.
Blinking The WRE6505 is sending/receiving data through the wireless LAN.
Off WLAN is off.
LAN On (Green) The WRE6505 has a successful 10/100MB LAN connection.
Blinking
(Green)
The WRE6505 is transmitting data.
Off Link is off.
WPS On (Blue) This remains on for 5 minutes after a successful WPS connection has been
established.
Blinking
(Blue)
The WRE6505 is waiting for another WPS device to connect.
Off There is no WPS connection established.
Table 1 Front Panel LEDs and WPS Button (continued)
LED STATUS DESCRIPTION
2.4G
To Next Page
Loading...
