Chapter 11 Maintenance
WRE6505 User’s Guide
69
If you uploaded the default configuration file you may need to change the IP address of your
computer to be in the same subnet as that of the default WRE6505 IP address (192.168.1.2). Refer
to your operating system’s help files for details on how to set up your computer’s IP address.
11.6.3 Restore to Factory Defaults
Pressing the WPS button (see Section 1.4 on page 11) on the front panel for more than 10 seconds
resets the factory defaults of your WRE6505. Refer to Section 1.4 on page 11 for more information
on the resetting the WRE6505.
11.7 Language
Click Maintenance > Language to select the language for use in the user interface.
Figure 61 Maintenance > Language
The following table describes the labels in this menu.
11.8 System Mode
For further information on System Mode see Section 2.1.1 on page 12.
Table 34 Maintenance > Language
LABEL DESCRIPTION
Language
selection
Click the drop-down menu to select the display language.
Apply Click Apply to save your changes back to the WRE6505.
Cancel Click Cancel to reload the previous configuration for this screen.
To Next Page
Loading...
