ZyXEL Communications WRE6505 - Configuring Access Point Mode; Key Actions in Access Point Mode

WRE6505 User’s Guide
20
CHAPTER 4
Access Point Mode
4.1 Overview
In Access Point (AP) mode your WRE6505 bridges a wired network (LAN) and wireless LAN (WLAN)
in the same subnet. See the figure below for an example.
Figure 10 Wireless Internet Access in Access Point Mode
Note: See Chapter 8 on page 44 for an example of setting up a wireless network in
Access Point mode.
4.2 What You Can Do
•Use the Status screen (Section 4.4 on page 21) to view read-only information about your
WRE6505.
•Use the LAN screen (Chapter 10 on page 63) to set the IP address for your WRE6505 acting as
an access point.
•Use the Wireless LAN > WPS screen (Section 9.9 on page 59) to configure WPS on the
WRE6505 to associate to another access point.