ZyXEL Communications WRE6505 - Completing the Connection Wizard

Chapter 6 Connection Wizard
WRE6505 User’s Guide
32
Note: The wireless stations and WRE6505 must use the same SSID, channel ID, WPA-PSK
(if WPA-PSK is enabled) or WPA2-PSK (if WPA2-PSK is enabled) for wireless
communication.
2 Click Next to continue.
3 Type the selected network’s wireless password (key). The number of characters accepted by the
KEY field is shown in the following table.
Figure 19 Wizard Step 3: Enter Wireless Network Password
The following table describes the labels in this screen.
4 Click Next to continue and verify the password.
6.2.2.2 Completing the Connection Wizard
Complete the installation process by reviewing the wireless network settings and applying the
configuration.
Next Click this to start the next step in the AP setup process.
Exit Click this to exit the wizard.
Previous Click this to see the previous page of APs.
Next Click this to see the next page of APs.
Table 12 Network > Wireless LAN > AP Select (continued)
LABEL DESCRIPTION
Table 13 Maximum Key Lengths
ENCRYPTION KEY FORMAT KEY LENGTH
64-bit WEP ASCII 5 characters
Hex 10 characters
128-bit WEP ASCII 13 characters
Hex 26 characters
WPA pre-shared key Passphrase 8-63 characters
Hex 64 characters