ZyXEL Communications WRE6505 - WPS Station Screen for Adding Devices

Chapter 9 Wireless LAN
WRE6505 User’s Guide
60
Figure 49 Network > Wireless LAN (2.4G/5G) > WPS
The following table describes the labels in this screen.
9.10 WPS Station Screen
Use this screen (available in AP mode only) when you want to add a wireless station using WPS. To
open this screen, click Network > Wireless LAN (2.4/5G) > WPS Station tab.
Table 26 Network > Wireless LAN (2.4G/5G) > WPS
LABEL DESCRIPTION
WPS Setup
WPS Select this to enable the WPS feature.
PIN Number This displays a PIN number last time system generated. Click Generate to generate a
new PIN number.
WPS Status
Status This displays Configured when the WRE6505 has connected to a wireless network using
WPS or when Enable WPS is selected and wireless or wireless security settings have
been changed. The current wireless and wireless security settings also appear in the
screen.
This displays Unconfigured if WPS is disabled and there are no wireless or wireless
security changes on the WRE6505 or click Release Configuration (AP mode only) to
remove the configured wireless and wireless security settings.
Release
Configuration
(AP mode only)
This button is only available when the WPS status displays Configured.
Click this button to remove all configured wireless and wireless security settings for WPS
connections on the WRE6505.
802.11 Mode This is the 802.11 mode used. Only compliant WLAN devices can associate with the
WRE6505.
SSID This is the name of the wireless network (the WAP3205 v2’s first SSID).
Security This is the type of wireless security employed by the network.
Apply Click Apply to save your changes back to the WRE6505.
Cancel Click Cancel to return to the previous menu without saving.