Chapter 9 Wireless LAN
WRE6505 User’s Guide
56
9.5 Security
Figure 45 Universal Repeater Mode: Wireless LAN (2.4G/5G) > Security
The following table describes the labels in this screen.
9.6 AP Select Screen
Use this screen (available in repeater mode only) to choose an access point that you want the
WRE6505 to connect to. You should know the security settings of the target AP.
To open this screen, click Network > Wireless LAN (2.4G/5G) > AP Select tab.
Apply Click Apply to save your changes back to the WRE6505.
Cancel Click Cancel to return to the previous menu without saving.
Table 21 Network > Wireless LAN (2.4G/5G) > General (continued)
LABEL DESCRIPTION
Table 22 Universal Repeater Mode: Wireless LAN (2.4G/5G) > Security
LABEL DESCRIPTION
Security
SSID Enter the name of the access point to which you are connecting.
Security Mode Select No Security or the available modes to match as provided by the source AP or
wireless router.
Pre-Shared Key Enter the security pre-shared key as provided by the source AP or wireless router.
Group Key Update
Timer
The Group Key Update Timer is the rate at which the AP sends a new group key out to all
clients.
The default is 3600 seconds (60 minutes).
Apply Click Apply to save your changes back to the WRE6505.
Cancel Click Cancel to reload the previous configuration for this screen.
To Next Page
Loading...
