ZyXEL Communications WRE6505 - Selecting an AP from an Automatically Detected List

Chapter 8 Tutorials
WRE6505 User’s Guide
48
• Selecting an AP by Manually Entering Security Information - create a secure wireless
network by manually entering the AP’s wireless security settings in the WRE6505’s interface. See
Section 8.4.2 on page 50. This is useful when the AP is hidden.
8.4.1 Selecting an AP from an Automatically Detected List
Follow the steps below to create a secure wireless network by selecting an AP from a list of detected
APs.
The AP select function is only available in repeater mode. See Section 2.1.1 on page 12.
The instructions require that your hardware is connected (see the Quick Start Guide) and you are
logged into the Web Configurator through your LAN connection (see Section 5.2 on page 26).
1 Select an AP form the Select column and click Next.
Figure 36 Tutorial: Selecting an automatically detected AP
2 Type a key into the KEY field and click Next.
Figure 37 Tutorial: The KEY field
3 Wait for the WRE6505 to verify the key with the AP.