Chapter 6 Connection Wizard
WRE6505 User’s Guide
35
6.2.2.3 Manually Configuring AP Parameters
If the AP you want to connect to is not listed, then follow these steps to configure the security
settings of the AP manually.
1 Select Setup repeater manually.
2 Type the SSID of the wireless router into the SSID field.
3 Click Next to continue.
Figure 24 Wizard Step 1: Entering the SSID
4 Select the security mode used by the wireless router from the drop-down menu.
5 Configure the security settings. The number of characters accepted by the KEY field is shown in the
following table.
Figure 25 Wizard Step 2: Configuring Security Settings
To Next Page
Loading...
