XMG3512-B10A User’s Guide
125
CHAPTER 9
Routing
9.1 Overview
The XMG usually uses the default gateway to route outbound traffic from computers on the LAN to the
Internet. To have the XMG send data to devices not reachable through the default gateway, use static
routes.
For example, the next figure shows a computer (A) connected to the XMG’s LAN interface. The XMG
routes most traffic from A to the Internet through the XMG’s default gateway (R1). You create one static
route to connect to services offered by your ISP behind router R2. You create another static route to
communicate with a separate network behind a router R3 connected to the LAN.
Figure 59 Example of Routing Topology
9.2 The Routing Screen
Use this screen to view and configure the static route rules on the XMG. Click Network Setting > Routing
> Static Route to open the following screen.
Figure 60 Network Setting > Routing > Static Route
To Next Page
Loading...
