XMG3512-B10A User’s Guide
221
CHAPTER 29
Remote Management
29.1 Overview
Remote management controls through which interface(s), which services can access the XMG.
Note: The XMG is managed using the Web Configurator.
29.2 The MGMT Services Screen
Use this screen to configure through which interface(s), which services can access the XMG. You can
also specify the port numbers the services must use to connect to the XMG. Click Maintenance >
Remote Management > MGMT Services to open the following screen.
Figure 141 Maintenance > Remote Management > MGMT Services
The following table describes the fields in this screen.
Table 112 Maintenance > Remote Management > MGMT Services
LABEL DESCRIPTION
WAN Interface
used for services
Select Any_WAN to have the XMG automatically activate the remote management service
when any WAN connection is up.
Select Multi_WAN and then select one or more WAN connections to have the XMG activate the
remote management service when the selected WAN connections are up.
service This is the service you may use to access the XMG.
LAN/WLAN Select the Enable check box for the corresponding services that you want to allow access to the
XMG from the LAN/WLAN.
WAN Select the Enable check box for the corresponding services that you want to allow access to the
XMG from all WAN connections.
To Next Page
Loading...
