Chapter 6 Broadband
XMG3512-B10A User’s Guide
71
6.2.1.2 Bridge Mode
Click the Add new WAN Interface in the Network Setting > Broadband screen or the Edit icon next to the
connection you want to configure. Select Bridge as the encapsulation mode. The screen varies
depending on the interface type you select.
If you select ADSL/VDSL over PTM or Ethernet as the interface type, the following screen appears.
Figure 25 Network Setting > Broadband > Add New WAN Interface/Edit (ADSL/VDSL over PTM -Bridge
Mode)
IPv6 DNS Server
This is available only when you select IPv4 IPv6 DualStack or IPv6 Only in the IPv4/IPv6 Mode field. Configure the
IPv6 DNS server in the following section.
Obtain IPv6 DNS
Info
Automatically
Select Obtain IPv6 DNS Info Automatically to have the XMG get the IPv6 DNS server addresses
from the ISP automatically.
Use Following
Static IPv6 DNS
Address
Select Use Following Static IPv6 DNS Address to have the XMG use the IPv6 DNS server addresses
you configure manually.
Primary DNS
Server
Enter the first IPv6 DNS server address assigned by the ISP.
Secondary DNS
Server
Enter the second IPv6 DNS server address assigned by the ISP.
Apply Click Apply to save your changes back to the XMG.
Cancel Click Cancel to exit this screen without saving.
Table 9 Network Setting > Broadband > Add New WAN Interface/Edit (Routing Mode) (continued)
LABEL DESCRIPTION
To Next Page
Loading...
