ZyXEL Communications XMG3512-B10A - Modify 802.1 X Settings; Technical Reference

Chapter 6 Broadband
XMG3512-B10A User’s Guide
78
6.5.1 Modify 802.1X Settings
Use this screen to edit 802.1X authentication settings. Click the Edit icon next to the rule you want to edit.
The screen shown next appears.
Figure 30 Network Setting > Broadband > 802.1x > Modify
The following table describes the labels in this screen.
6.6 Technical Reference
The following section contains additional technical information about the XMG features described in this
chapter.
Encapsulation
Be sure to use the encapsulation method required by your ISP. The XMG can work in bridge mode or
routing mode. When the XMG is in routing mode, it supports the following methods.
Table 16 Network Setting > Broadband > 802.1x: Edit
LABEL DESCRIPTION
Active This field allows you to activate/deactivate the authentication.
Select this to enable the authentication. Clear this to disable this authentication without having
to delete the entry.
Interface Select an interface to which the authentication applies.
EAP Identity Enter the EAP identity of the authentication.
EAP method This is the EAP method used for this authentication.
Bidirectional
Authentication
Select Enable to allow bidirectional authentication.
Certificate Select the certificate you want to assign to the authentication. You need to import the
certificate in the Security > Certificates > Local Certificates screen.
Trusted CA Select the Trusted CA you want to assign to the authentication. You need to import the
certificate in the Security > Certificates > Trusted CA screen.
OK Click OK to save your changes.
Cancel Click Cancel to exit this screen without saving.