ZyXEL Communications XMG3512-B10A - Page 187

Chapter 16 Firewall
XMG3512-B10A User’s Guide
187
Figure 111 Access Control: Add/Edit
The following table describes the labels in this screen.
Table 83 Access Control: Add/Edit
LABEL DESCRIPTION
Filter Name Enter a descriptive name of up to 16 alphanumeric characters, not including spaces,
underscores, and dashes.
You must enter the filter name to add an ACL rule. This field is read-only if you are editing the
ACL rule.
Order Select the order of the ACL rule.
Select Source
Device
Select the source device to which the ACL rule applies. If you select Specific IP Address, enter
the source IP address in the field below.
Source IP
Address
Enter the source IP address.
Select
Destination
Device
Select the destination device to which the ACL rule applies. If you select Specific IP Address,
enter the destiniation IP address in the field below.
Destination IP
Address
Enter the destination IP address.
IP Type Select whether your IP type is IPv4 or IPv6.
Select Service Select the transport layer protocol that defines your customized port from the drop-down list
box. The specific protocol rule sets you add in the Security > Firewall > Service > Add screen
display in this list.
If you want to configure a customized protocol, select Specific Service.
Protocol This field is displayed only when you select Specific Protocol in Select Protocol.
Choose the IP port (TCP/UDP, TCP, UDP, ICMP, or ICMPv6) that defines your customized port from
the drop-down list box.