Chapter 17 MAC Filter
XMG3512-B10A User’s Guide
190
The following table describes the labels in this screen.
Table 85 Security > MAC Filter
LABEL DESCRIPTION
MAC Address Filter Select Enable to activate the MAC filter function.
MAC Restrict Mode Select Allow to only permit the listed MAC addresses access to the XMG. Select Deny to
permit anyone access to the XMG except the listed MAC addresses.
Set This is the index number of the MAC address.
Active Select Active to enable the MAC filter rule. . The rule will not be applied if Active is not
selected.
Host Name Enter the host name of the wireless or LAN clients that are allowed access to the XMG.
MAC Address Enter the MAC addresses of the wireless or LAN clients that are allowed access to the XMG
in these address fields. Enter the MAC addresses in a valid MAC address format, that is, six
hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
Apply Click Apply to save your changes.
Cancel Click Cancel to restore your previously saved settings.
To Next Page
Loading...
