ZyXEL Communications XMG3512-B10A - Page 47

Chapter 4 Tutorials
XMG3512-B10A User’s Guide
47
In the following figure, router R is connected to the XMG’s LAN. R connects to two networks, N1
(192.168.1.x/24) and N2 (192.168.10.x/24). If you want to send traffic from computer A (in N1 network) to
computer B (in N2 network), the traffic is sent to the XMG’s WAN default gateway by default. In this
case, B will never receive the traffic.
You need to specify a static routing rule on the XMG to specify R as the router in charge of forwarding
traffic to N2. In this case, the XMG routes traffic from A to R and then R routes the traffic to B.
This tutorial uses the following example IP settings:
Table 5 IP Settings in this Tutorial
DEVICE / COMPUTER IP ADDRESS
The XMG’s WAN 172.16.1.1
The XMG’s LAN 192.168.1.1
IP Type IPv4
Use Interface VDSL/ppp1.1
A 192.168.1.34
R’s N1 192.168.1.253
N2
B
N1
A
R
N2
B
N1
A
R