Configuration manual for 2N IP intercoms
•
•
•
•
•
•
•
•
•
•
•
•
•
13.56 MHz (125 kHz) Card Reader (serial number)
Module Name– set the module name for card reader logging purposes.
Door–set the reader direction (Not specified, Arrival, Departure) for the Attendance
system purposes.
Associated Switch–set the switch to be activated after user authentication via this
module. If you set Door Lock Switch, the authentication rules specified in Hardware / Door
will be used.
Allowed Card Types– set the type of a card to be accepted by the card reader. The card
reader supports just one card type at an instant.
Samsung NFC Compatibility–enable NFC compatibility with the Samsung phones.
Credentials Forward Group– allows you to set a group to which all received user access
codes will be forwarded.
Touch Keypad (serial number)
Module Name–set the module name for logging events from the touch keypad module.
Door–set thereader direction (Door Entry, Door Exit) for the Attendance system
purposes.
Blink at Keystroke– setkeystroke light signalling for noisy environments where acoustic
signals are difficult to hear.
Credentials Forward Group– set the group to which all the received user access codes
will be resent.
Transmitted Code Format– select a 4bit or 8bit (higher security) format for the codes to
be transmitted.
Bluetooth(serial number)
Module Name–set the module name for logging events from the Bluetooth module.
Door–set the reader direction (Not specified, Arrival, Departure) for the Attendance
system purposes.
To Next Page
Loading...
Need help?
General
