Defining SNMP Traps 139
■ Access Mode — Displays the access rights of the community. The
possible field values are:
■ Read Only — Management access is restricted to read-only, and
changes cannot be made to the community.
■ Read Write — Management access is read-write and changes can
be made to the device configuration, but not to the community.
2 Select the SNMP Community to be removed.
3 Click Remove. The SNMP Community is removed, and the device is
updated.
Defining SNMP
Traps
The SNMP Traps Setup Page contains information for defining filters that
determine whether traps are sent to specific users, and the trap type sent.
Monitor users have no access to this page.
To define SNMP traps:
1 Click Administration > SNMP > Traps. The SNMP Traps Setup Page
opens:
Figure 74 SNMP Traps Setup Page
To Next Page
Loading...
