3Com 2924-SFP - Viewing Bandwidth Settings

150 CHAPTER 13: CONFIGURING QUALITY OF SERVICE
Viewing Bandwidth
Settings
The Bandwidth Summary Page displays bandwidth settings for a specified
interface.
To view Bandwidth Settings:
1 Click Device > QoS > Bandwidth > Summary. The Bandwidth
Summary Page opens:
Figure 83 Bandwidth Summary Page
The Bandwidth Summary Page contains the following fields:
■ Interface — Displays the interface for which rate limit and shaping
parameters are defined.
Ingress Rate Limit
■ Status — Indicates if rate limiting is defined on the interface. The
possible field values are:
■ Enable — Enables ingress rate limiting on the interface.
■ Disable — Disables ingress rate limiting on the interface.
■ Rate Limit — Indicates the traffic limit for the port. The field range is
3,500-1,000,000 kbps per second.