3Com 4200G 24-Port - Setting the Priority of Protocol Packets

1-17
36 : 7
37 : 7
38 : 7
39 : 7
40 : 0
41 : 0
42 : 0
43 : 0
44 : 0
45 : 0
46 : 0
47 : 0
48 : 5
49 : 5
50 : 5
51 : 5
52 : 5
53 : 5
54 : 5
55 : 5
56 : 6
57 : 6
58 : 6
59 : 6
60 : 6
61 : 6
62 : 6
63 : 6
Setting the Priority of Protocol Packets
Refer to Protocol Priority for information about priority of protocol packets.
Configuration prerequisites
z The protocol type has been determined.
z The priority type (IP or DSCP) and priority value have been determined.
Configuration procedure
Follow these steps to set the priority of the specific protocol packets:
To do… Use the command… Remarks
Enter system view
system-view
—
Set the priority of the
specific type of protocol
packets
protocol-priority
protocol-type
protocol-type
{ ip-precedence
ip-precedence | dscp
dscp-value }
Required
You can modify the IP precedence values
or DSCP values of the corresponding
protocol packets.
On a Switch 4200G, you can set the
priority for protocol packets of Telnet,
SNMP, and ICMP.