8-2
Operation Command Description
Specify a source interface for
Telnet server
telnet-server source-interface
interface-type interface-number
Optional
Specify source IP address for
Telnet client
telnet source-ip ip-address
Optional
Specify a source interface for
Telnet client
telnet source-interface interface-type
interface-number
Optional
To perform the configurations listed in Table 8-1 and Table 8-2, make sure that:
z The IP address specified is that of the local device.
z The interface specified exists.
z If a source IP address (or source interface) is specified, you need to make sure that the route
between the IP addresses (or interface) of both sides is reachable.
Displaying Source IP Address Configuration
Execute the display command in any view to display the operation state after the above configurations.
You can verify the configuration effect through the displayed information.
Table 8-3 Display the source IP address configuration
Operation Command Description
Display the source IP address
configured for the Telnet client
display telnet source-ip
Display the source IP address
configured for the Telnet server
display telnet-server
source-ip
You can execute the two
commands in any view.
To Next Page
Loading...
