1-7
Source
This field indicates the source of the information, such as the source IP address of the log sender. This
field is optional and is displayed only when the output destination is the log host.
Context
This field provides the content of the system information.
Information Center Configuration
Information Center Configuration Task List
Complete the following tasks to configure information center:
Task Remarks
Configuring Synchronous Information Output Optional
Configuring to Display the Time Stamp with the UTC Time Zone Optional
Setting to Output System Information to the Console Optional
Setting to Output System Information to a Monitor Terminal Optional
Setting to Output System Information to a Log Host Optional
Setting to Output System Information to the Trap Buffer Optional
Setting to Output System Information to the Log Buffer Optional
Setting to Output System Information to the SNMP NMS Optional
Configuring Synchronous Information Output
Synchronous information output refers to the feature that if the system information such as log, trap, or
debugging information is output when the user is inputting commands, the command line prompt (in
command editing mode a prompt, or a [Y/N] string in interaction mode) and the input information are
echoed after the output.
This feature is used in the case that your input is interrupted by a large amount of system output. With
this feature enabled, the system echoes your previous input and you can continue your operations from
where you were stopped.
Follow these steps to configure synchronous information output:
To do… Use the command… Remarks
Enter system view
system-view
—
Enable synchronous
information output
info-center synchronous
Required
Disabled by default
To Next Page
Loading...
