2-18
Operation Command Description
Display the information about
all the devices in the base
cluster topology
display cluster
base-members
Configure cluster device blacklist
Perform the following configuration on the management device.
Table 2-20 Configure the cluster device blacklist
Operation Command Description
Enter system view
system-view
—
Enter cluster view
cluster
—
Add the MAC address of a
specified device to the cluster
blacklist
black-list add-mac
mac-address
Optional
By default, the cluster blacklist
is empty.
Delete the specified MAC
address from the cluster
blacklist
black-list delete-mac
mac-address
Optional
Delete a device from the cluster
add this device to the cluster
blacklist
delete-member member-id
[ to-black-list ]
Optional
Displays the information about
the devices in the cluster
blacklist
display cluster black-list
Optional
This command can be
executed in any view.
Configuring the Cluster Synchronization Function
After a cluster is established, to simplify the access and management to the cluster, you can
synchronize the SNMP configurations on the management device and the local user configurations to
the member devices of the cluster by configuring the cluster synchronization function.
SNMP configuration synchronization
With this function, you can configure the public SNMP community name, SNMP group, SNMP users
and MIB views. These configurations will be synchronized to the member devices of the cluster
automatically, which not only simplifies the configurations on the member devices, but also enables the
network management station (NMS) to access any member device of the cluster conveniently.
For the SNMP configurations, refer to the SNMP-RMON Operation part in this manual.
1) Configuration prerequisites
To Next Page
Loading...
