3Com 4200G 24-Port - Configuring a Smart Link Device

1-4
Task Remarks
Create a smart link group
Add member ports to the smart link group
Configuring a Smart Link
Device
Enable the function of sending flush messages
in the specified control VLAN
Required
Configuring Associated
Devices
Enable the function of processing flush
messages received from the specified control
VLAN
Required
Configuring a Smart Link Device
A Smart Link device refers to a device on which Smart Link is enabled and a smart link group is
configured, and that sends flush messages from the specified control VLAN. A member port of a smart
link group can be either an Ethernet port or a manually-configured or static LACP aggregation group.
You can configure a port or a link aggregation group as a member of a smart link group.
Follow these steps to configure Smart Link (with ports as the members of the smart link group):
To do… Use the command… Remarks
Enter system view
system-view
—
Create a smart link group and
enter smart link group view
smart-link group group-id
Required
Enable the function of sending
flush messages in the
specified control VLAN
flush enable control-vlan vlan-id
Required
By default, no
control VLAN for
sending flush
messages is
specified.
smart link
group view
port interface-type interface-number { master |
slave }
quit
interface interface-type interface-number
Configure a
port as a
smart link
group
member
Ethernet port
view
port smart-link group group-id { master |
slave }
Required
Use either
approach
Follow these steps to configure Smart Link (with link aggregation groups are the members of the smart
link group):
To do… Use the command… Remarks
Enter system view
system-view
—
Create a smart link group and
enter smart link group view
smart-link group
group-id
Required
Configure a link aggregation
group as a member of the
smart link group
link-aggregation group
group-id
{
master
|
slave
}
Optional