2-1
2 Basic System Configuration and Debugging
When configuring basic system configuration and debugging, go to these sections for information you
are interested in:
z Basic System Configuration
z Displaying the System Status
z Debugging the System
Basic System Configuration
Perform the following basic system configuration:
To do… Use the command… Remarks
Set the current date and time of
the system
clock datetime HH:MM:SS
{ YYYY/MM/DD |
MM/DD/YYYY }
Required
Execute this command in user
view.
The default value is 23:55:00
04/01/2000 when the system
starts up.
Set the local time zone
clock timezone zone-name
{ add | minus } HH:MM:SS
Optional
Execute this command in user
view.
By default, it is the UTC time zone.
Set the name and time range of
the summer time
clock summer-time
zone_name { one-off |
repeating } start-time
start-date end-time
end-date offset-time
Optional
Execute this command in user
view.
z When the system reaches the
specified start time, it
automatically adds the
specified offset to the current
time, so as to toggle the system
time to the summer time.
z When the system reaches the
specified end time, it
automatically subtracts the
specified offset from the current
time, so as to toggle the
summer time to normal system
time.
Enter system view from user
view
system-view
—
Set the system name of the
switch
sysname sysname
Optional
By default, the name is 3Com.
Return from current view to
lower level view
quit
Optional
If the current view is user view, you
will quit the current user interface.
To Next Page
Loading...
