4-5
To do… Use the command… Remarks
Display the currently measured
value of the digital diagnosis
parameters of the
anti-spoofing optical
transceiver(s) customized by
H3C
display transceiver
diagnosis interface
[ interface-type
interface-number ]
Available for anti-spoofing
pluggable optical transceiver(s)
customized by H3C only
Displaying the Device Management Configuration
To do… Use the command… Remarks
Display the APP to be adopted at
next startup
display boot-loader [ unit unit-id ]
Display the module type and
operating status of each board
display device [ manuinfo | unit
unit-id ]
Display CPU usage of a switch display cpu [ unit unit-id ]
Display the operating status of the
fan
display fan [ unit unit-id [ fan-id ] ]
Display memory usage of a switch display memory [ unit unit-id ]
Display the operating status of the
power supply
display power [ unit unit-id
[ power-id ] ]
Display system diagnostic
information or save system
diagnostic information to a file with
the extension .diag into the Flash
memory
display diagnostic-information
Display enabled debugging on a
specified switch
display debugging { unit unit-id }
[ interface interface-type
interface-number ] [ module-name ]
Available in any
view.
Remote Switch APP Upgrade Configuration Example
Network requirements
Telnet to the switch from a PC remotely and download applications from the FTP server to the Flash
memory of the switch. Update the switch software by using the device management commands through
CLI.
The switch acts as the FTP client, and the remote PC serves as both the configuration PC and the FTP
server.
Perform the following configuration on the FTP server.
z Configure an FTP user, whose name is switch and password is hello. Authorize the user with the
read-write right on the directory Switch on the PC.
z Make configuration so that the IP address of a VLAN interface on the switch is 1.1.1.1, the IP
address of the PC is 2.2.2.2, and the switch and the PC is reachable to each other.
To Next Page
Loading...
