3Com 4200G 24-Port - Specifying a Configuration File for Next Startup

1-4
To do… Use the command… Remarks
Erase the startup configuration
file from the storage switch
reset saved-configuration
[ backup | main ]
Required
Available in user view
You may need to erase the configuration file for one of these reasons:
z After you upgrade software, the old configuration file does not match the new software.
z The startup configuration file is corrupted or not the one you needed.
The following two situations exist:
z While the reset saved-configuration [ main ] command erases the configuration file with main
attribute, it only erases the main attribute of a configuration file having both main and backup
attribute.
z While the reset saved-configuration backup command erases the configuration file with backup
attribute, it only erases the backup attribute of a configuration file having both main and backup
attribute.
This command will permanently delete the configuration file from the switch.
Specifying a Configuration File for Next Startup
Use the following command to specify a configuration file for next startup:
To do… Use the command… Remarks
Specify a configuration file for
next startup
startup saved-configuration
cfgfile [ backup | main ]
Required
Available in user view
You can specify a configuration file to be used for the next startup and configure the main/backup
attribute for the configuration file.
Assigning main attribute to the startup configuration file
z If you save the current configuration to the main configuration file, the system will automatically set
the file as the main startup configuration file.
z You can also use the startup saved-configuration cfgfile [ main ] command to set the file as main
startup configuration file.
Assigning backup attribute to the startup configuration file
z If you save the current configuration to the backup configuration file, the system will automatically
set the file as the backup startup configuration file.
z You can also use the startup saved-configuration cfgfile backup command to set the file as
backup startup configuration file.