1-17
5 3 1 0 2000-04-02 20:55:12.2
For detailed output description, see the corresponding command manual.
DHCP Test
Network requirements
Both the remote-ping client and the DHCP server are 4200G Ethernet switches. Perform a remote-ping
DHCP test between the two switches to test the time required for the remote-ping client to obtain an IP
address from the DHCP server.
Network diagram
Figure 1-3 Network diagram for the DHCP test
Configuration procedure
z Configure DHCP Server(Switch B):
Configure DHCP server on Switch B. For specific configuration of DHCP server, refer to the DHCP part
of the manual.
z Configure remote-ping Client (Switch A):
# Enable the remote-ping client.
<Sysname> system-view
[Sysname] remote-ping-agent enable
# Create a remote-ping test group, setting the administrator name to administrator and test tag to
DHCP.
[Sysname] Remote-ping administrator dhcp
# Configure the test type as dhcp.
[Sysname-remote-ping-administrator-dhcp] test-type dhcp
# Configure the source interface, which must be a VLAN interface. Make sure the DHCP server resides
on the network connected to this interface.
[Sysname-remote-ping-administrator-dhcp] source-interface Vlan-interface 1
# Configure to make 10 probes per test.
[Sysname-remote-ping-administrator-dhcp] count 10
# Set the probe timeout time to 5 seconds.
[Sysname-remote-ping-administrator-dhcp] timeout 5
# Start the test.
[Sysname-remote-ping-administrator-dhcp] test-enable
# Display test results
[Sysname-remote-ping-administrator-dhcp] display remote-ping results administrator dhcp
To Next Page
Loading...
