2-17
connected to the current cluster, this device cannot join the cluster and participate in the unified
management and configuration of the cluster.
Configure the enhanced cluster features
Table 2-18 The enhanced cluster feature configuration tasks
Operation Description
Configure cluster topology management function Required
Configure cluster device blacklist Required
Configure cluster topology management function
1) Configuration prerequisites
Before configuring the cluster topology management function, make sure that:
z The basic cluster configuration is completed.
z Devices in the cluster work normally.
2) Configuration procedure
Perform the following configuration on the management device.
Table 2-19 Configure cluster topology management function
Operation Command Description
Enter system view
system-view
—
Enter cluster view
cluster
—
Check the current topology and
save it as the standard
topology.
topology accept { all [ save-to
{ ftp-server | local-flash } ] |
mac-address mac-address |
member-id member-id |
administrator }
Required
Save the standard topology to
the Flash memory of the
administrative device
topology save-to local-flash
Required
Restore the standard topology
from the Flash memory of the
administrative device
topology restore-from
local-flash
Optional
Display the detailed information
about a single device
display ntdp single-device
mac-address mac-address
Display the topology of the
current cluster
display cluster
current-topology
[ mac-address mac-address1
[ to-mac-address
mac-address2 ] | member-id
member-id1 [ to-member-id
member-id2 ] ]
Display the information about
the base topology of the cluster
display cluster
base-topology [ mac-address
mac-address | member
member-id ]
Optional
These commands can be
executed in any view.
To Next Page
Loading...
