1-4
To do… Use the command… Remarks
Enter system view
system-view
—
Specify the source interface for
an FTP server
ftp-server source-interface
interface-type interface-number
Specifying the source IP
address for an FTP server
ftp-server source-ip ip-address
Use either command
Not specified by default.
z The specified interface must be an existing one. Otherwise a prompt appears to show that the
configuration fails.
z The value of the ip-address argument must be an IP address on the device where the configuration
is performed. Otherwise a prompt appears to show that the configuration fails.
z You can specify only one source interface or source IP address for the FTP at one time. That is,
only one of the commands ftp-server source-interface and ftp-server source-ip can be valid at
one time. If you execute both of them, the new setting will overwrite the original one.
z If the switch (FTP server) is the command switch or member switch in a cluster, do not use the
ftp-server source-ip command to specify the private IP address of the cluster as the source IP
address of the FTP server. Otherwise, FTP does not take effect.
Disconnecting a specified user
On the FTP server, you can disconnect a specified user from the FTP server to secure the network.
Follow these steps to disconnect a specified user:
To do… Use the command… Remarks
Enter system view
system-view
—
On the FTP server, disconnect
a specified user from the FTP
server
ftp disconnect user-name
Required
With a 3com switch 4200G acting as the FTP server, if a network administrator attempts to disconnect
a user that is uploading/downloading data to/from the FTP server the 3com switch 4200G will
disconnect the user after the data transmission is completed.
Configuring the banner for an FTP server
Displaying a banner: With a banner configured on the FTP server, when you access the FTP server
through FTP, the configured banner is displayed on the FTP client. Banner falls into the following two
types:
To Next Page
Loading...
