1-11
To do… Use the command… Remarks
Configure the automatic test
interval
frequency interval
Optional
By default, the automatic test
interval is zero seconds,
indicating no automatic test will
be made.
Configure the probe timeout
time
timeout time
Optional
By default, a probe times out in
three seconds.
Configure the type of service
tos value
Optional
By default, the service type is
zero.
Start the test
test-enable
Required
Display test results
display remote-ping results
[ admin-name operation-tag ]
Required
You can execute the command
in any view.
7) Configuring TCP test on remote-ping client
Follow these steps to configure TCP test on remote-ping client:
To do… Use the command… Remarks
Enter system view
system-view
—
Enable the remote-ping
client function
remote-ping-agent enable
Required
By default, the remote-ping client
function is disabled.
Create a remote-ping
test group and enter its
view
remote-ping
administrator-name
operation- tag
Required
By default, no test group is configured.
Configure the destination
address
destination-ip ip-address
Required
This IP address and the one configured
on the remote-ping server for listening
services must be the same.
By default, no destination address is
configured.
Configure the destination
port
destination-port
port-number
Required in a Tcpprivate test
A Tcppublic test is a TCP connection
test on port 7. Use the
remote-ping-server tcpconnect
ip-address 7 command on the server to
configure the listening service port;
otherwise the test will fail. No port
number needs to be configured on the
client; any destination port number
configured on the client will not take
effect.
By default, no destination port number is
configured.
Configure the source IP
address
source-ip ip-address
Optional
By default, the source IP address is not
specified.
To Next Page
Loading...
