3Com 4200G 24-Port - Page 643

1-13
To do… Use the command… Remarks
Configure the
destination port
destination-port
port-number
z Required in a Udpprivate test
z A Udppublic test is a UDP connection
test on port 7. Use the
remote-ping-server udpecho ip-address
7 command on the server to configure
the listening service port; otherwise the
test will fail. No port number needs to be
configured on the client; any destination
port number configured on the client will
not take effect.
z By default, no destination port number is
configured.
Configure the source
IP address
source-ip ip-address
Optional
By default, no source IP address is
configured.
Configure the source
port
source-port port-number
Optional
By default, no source port is specified.
Configure the test
type
test-type { udpprivate |
udppublic }
Required
By default, the test type is ICMP.
Configure the number
of probes per test
count times
Optional
By default, one probe is made per test.
Configure the
maximum number of
history records that
can be saved
history-records number
Optional
By default, the maximum number is 50.
Configure the data
packet size
datasize size
Optional
By default, the data packet size is 100
bytes.
Configure the
automatic test interval
frequency interval
Optional
By default, the automatic test interval is
zero seconds, indicating no automatic test
will be made.
Configure the probe
timeout time
timeout time
Optional
By default, a probe times out in three
seconds.
Configure the service
type
tos value
Optional
By default, the service type is zero.
Start the test
test-enable
Required
Display test results
display remote-ping
results [ admin-name
operation-tag ]
Required
The display command can be executed in
any view.
9) Configuring DNS test on remote-ping client
Follow these steps to configure DNS test on remote-ping client:
To do… Use the command… Remarks
Enter system view system-view —