12
ADMINISTERING IPX ROUTING
This chapter describes how to set up your CoreBuilder
™
2500
system to
use the Internet Packet Exchange (IPX) protocol to route packets.
The
chapter discusses these tasks:
■ Administering Interfaces
■ Administering Routes
■ Administering Servers
■ Setting IPX Forwarding
■ Setting the RIP Mode
■ Setting the Enhanced RIP Mode
■ Setting RIP Triggered Updates
■ Setting the SAP Mode
■ Setting SAP Triggered Updates
■ Displaying Statistics
For information about how IPX works, see Chapter 6, “Routing with
IPX.”
To Next Page
