3Com CoreBuilder 2500 - Page 241

INDEX 7
R
rate limit, IP multicast 5-5, 11-3
references
Comer
4-11
IP 4-11
OSPF 4-11
Perlman 4-11
RIP 4-11
routing RFCs 4-11
Sterns 4-11
returning products for repair A-5
reverse path forwarding algorithm
IP multicast routing
5-4
RIP
broadcast address, and
10-21
RIP (Routing Information Protocol)
active mode
10-20
adding advertisement address 10-21
default mode 10-20
defined 4-6, 6-9
displaying interface configuration 10-19
displaying statistics 10-22
interface cost 10-20, 10-21
location in OSI Reference Model 4-1
off mode 10-20
passive mode 10-20
removing advertisement address 10-22
route configuration, and 4-6, 6-9
setting interface cost 10-20, 10-21
setting mode 10-20
setting poison reverse mode 10-21
using for dynamic routes 6-9
RIP mode, IPX
setting
12-9
RIP triggered updates, IPX
setting
12-10
RMON (Remote Monitoring)
agents
15-9
alarms 15-5, 15-6
benefits of 15-2
event group 15-8
host group 15-8
hostTopN group 15-8
hysteresis mechanism 15-7
management console 15-1
matrix group 15-8
MIB 15-1, 15-2, 15-10
probe 15-1, 15-2
statistics 15-4, 15-5
route, AppleTalk
administering
14-4
displaying 14-4
flushing 14-5
route, IP
default
10-8
defining static 10-9
gateway address 10-8
metric 10-8
removing default 10-11
removing from table 10-10
status 10-8
subnet mask 10-8
route, IPX
administering
12-4
removing 12-6
router databases, OSPF 7-5
router ID, OSPF 7-8
router interface, IP
described
4-4
diagram 4-4
router interface, IPX 6-7
routers
area border, OSPF
7-4, 7-8
autonomous system, OSPF 7-8
backbone, OSPF 7-7
backup designated, OSPF 7-8, 7-12
databases, OSPF 7-5, 13-15
designated, OSPF 7-8, 7-13
IDs, OSPF 7-8
internal, OSPF 7-7
seed 8-4
setting IDs, OSPF 13-23
routes, displaying IP multicast 11-7
routing
and bridging in switching modules
3-4
and bridging, traditional model 3-4
AppleTalk 8-1
CoreBuilder 2500 system, and the 3-1 to 3-7
inter-area, OSPF 7-14
intra-area, OSPF 7-14
to different autonomous system, OSPF 7-14
to stub area, OSPF 7-14
See also IP routing, IPX routing, and AppleTalk
routing
Routing Information Protocol. See RIP
routing table, AppleTalk
8-7
routing table, IP
contents
4-5, 10-8
default route 4-6
default route, setting 10-10
described 4-5
display routes 10-9
dynamic routes 4-6
example 4-5
flushing learned routes 10-10
metric 4-5
removing default route 10-11
removing route 10-10
static routes 4-6