Moisture Content (during or after weighing)
Format with Temperature Data (Function Table 5-d 1 )
– The first 3 figures are the temperature data.
The format consists of nineteen characters excluding the terminator.
9.3. Command
– The analyser can be controlled by the following commands from the computer.
Add a terminator (0Dh,0Ah) to each command.
Command Description
Q Outputs the current data.
SIR Outputs data continuously
C Stops data output after SIR command has been sent.
QM Outputs the data during measurement.
START Same as the START key
STOP Same as the STOP key
RESET Same as the RESET key
ENTER Same as the ENTER key
SELECT Same as the SELECT key
DOWN Same as the key
UP Same as the key
PROGRAM Same as the PROGRAM key
To Next Page
Loading...
