Page 34
Cleaning the cuff and recorder
Before cleaning the recorder, remove the battery cover and turn the power switch
off. Remove the batteries.
The recorder is not water resistant, do not allow liquids to splash on or get into the
case while cleaning.
After each use, wipe the case of the recorder with a clean lint free cloth, moistened
with water and a mild detergent.
Do not use antiseptic solutions, Alcohol, etc., to clean the recorder, hose or cuff.
Clean the cuff cloth and cuff cover by washing in water with a mild detergent. Do
not scrub or wring them by hand. If the cuff cloth and cuff cover become
contaminated, replace them with new covers.
Periodical inspection
This blood pressure recorder is a precision instrument. Please inspect the
functions (every year) periodically. Contact your nearest A&D office for this
inspection.
Problem solving
Caution
Do not open the case of the recorder because it uses delicate electrical
components and intricate air unit that could be damaged.
If you can not locate and fix the problem, request service from your supplier, or
from the A&D service group.
A&D service group will support authorized suppliers about technical information,
spare parts and units.
Problem Cause Treatment
No display at turning
on.
Battery power has been
consumed.
Replace with new batteries.
Data lost while
replacing batteries.
Unable to charge the
internal sub battery.
Set for clock display for approx.
24 hours. This battery charges
during clock display.
No pressure. Air leakage at the
connector, hose or cuff.
Confirm the cuff and air hose
are not damaged and are
connected correctly.
To Next Page
Loading...
