Page 16
The State of Turning on the Recorder
There are three types of state when the recorder is turned on. Select a operation.
Refer to the section "The complete procedure for use" about use.
Action when the
recorder is turned on.
State of recorder
Treatment
(Operation)
The buzzer sounds
once and the clock is
displayed. (Normal
state)
The recorder storage
parameters of "display
and clock" and "automatic
measurement".
You can use the recorder
at once.
The buzzer is sounded
once and is
displayed blinking.
All parameters are lost.
The buzzer sounds
four times and is
displayed blinking.
The state after reset. All
parameters are lost.
Set up parameters of
"display and clock" and
"Automatic measurement".
Parameters for the Display and Clock
This setting selects the display during automatic measurement sequence and
adjusts the clock parameters. The sequence number tells you which parameter you
are adjusting.
Display & key
Items
Sequence
number
Value &
range
Meaning of parameters
0 Displaying clock only in automatic measurement
1
1
Displaying pressure and result in automatic
measurement
5 00 ~ 99 Years (1997 ~ 2096)
6 01 ~ 12 Month
7 01 ~ 31 Day
8 00 ~ 23 Hour
9 00 ~ 59 Minute
Sequence number
Parameter
Sign of setting up parameters for display and clock
Selecting a sequence
number
Selecting a parameter
To Next Page
Loading...
