AAON RSMV ASM01686 - Figure 9: Prism 2 Condenser Configuration - Single Condenser for Four Modules

29
RSMV Technical Guide
APPENDIX A: CONDENSER OPTIONS
Single Condenser Conguration
Single Condenser Per Four Modules
In Single Condenser Per Four Modules wiring conguration, the
Condenser Signal is wired to AO2 on the 1st module but not the 2nd,
3rd, or 4th modules and the Condenser Relay (RLY3) is enabled on
the 1st module but not the 2nd, 3rd, or 4th modules.
Refer to Figure 9, below for Prism 2 conguration.
Figure 9: Prism 2 Condenser Conguration - Single Condenser for Four Modules
Modular Service Tool Screen
RSMV Condenser Options
Conguration Screen
RSM#1-4 CONFIGURATION
Condenser Options
1 Cond for 4 RSMVs
USE < or > TO CHANGE
Select the “1 Condenser for 4 RSMVs” option on the above Hand
Held Service Tool Screen.