Ascotel® IntelliGate® 150/300 as of I7.9
Installation 117
syd-0210/1.7 – I7.9 – 12.2009
Relay and control inputs
If the options card is fitted to slot IC1 (A150) or slot IC1, 2 or 3 (A300), the analogue
terminal interface cannot be used. However two control inputs can be used for
switching a switch group and two relay outputs for controlling external devices or
equipment.
Jumper Configuration
The jumper configuration is shown in the following diagram.
Fig. 60 Jumper configuration for relays and control inputs
Note
If the options card is fitted in slot IC1 (A150) or slot IC1, 2 or 3 (A300), the
jumpers must be fitted as shown in Fig. 60.
Tab. 50 Connection in slot IC1 (A150) or slot IC1, 2 or 3 (A300)
RJ45 A150/300 RJ45 A150/300
Socket X1 Pin Signal Socket X3 Pin Signal
1– 1–
2– 2–
3 O1-1 3 –
4 O2-1 4 –
5 O2-2 5 –
6 O1-2 6 –
7– 7–
8– 8–
0ORT
0ORT
0ORT
0ORT
#ONTROLINPUT
#ONTROLINPUT
2ELAIS
2ELAIS
To Next Page
Loading...
