Aastra Ascotel IntelliGate 150 - Page 79

Ascotel® IntelliGate® 150/300 as of I7.9
Installation 79
syd-0210/1.7 – I7.9 – 12.2009
Please note:
• The arrows on the wiring adapters specify the plug-in orientation of the required
port assignment.
• On the ESST-2 terminal card the jumper must always be fitted in position T (see
figure below). The port assignment is specified by the wiring adapter alone.
WA-2W ETAB4
3)
– a/b a/b a/b a/b
EADP4
3)
– AD2 AD2 AD2 AD2
EAD4C
1)
– AD2 AD2 AD2 AD2
EAD4V
1)
– AD2 AD2 AD2 AD2
EAAB2
1)
–––a/ba/b
TIC-4AB – a/b a/b a/b a/b
TIC-2AB – a/b a/b – –
WA-1PRI TIC-1PRI – T2 Test
4)
––
SM-LAN8
5)
– – LAN LAN LAN LAN
EADP4 – LAN+AD2 LAN+AD2 LAN+AD2 LAN+AD2
EAD4C – LAN+AD2 LAN+AD2 LAN+AD2 LAN+AD2
EAD4V – LAN+AD2 LAN+AD2 LAN+AD2 LAN+AD2
1)
The wiring adapter is not part of the equipment supplied with this interface card and must be ordered sepa-
rately.
2)
On the ESST-2 terminal card the jumper must always be fitted in position T (see Fig. 28).
3)
The wiring adapter is only part of the equipment supplied with order variant A150/300.
4)
For test purposes the T2 interface is also routed in parallel to port X.2.
5)
In combination with AD2 terminal cards the LAN switch module SM-LAN8 acts as two wiring adapters (not
allowed in Australia).
Wiring Adapter Interface card
Plug-in
orienta-
tion
Port number
X.1 X.2 X.3 X.4