Ascotel® IntelliGate® 150/300 as of I7.9
158 Operation and Maintenance
syd-0210/1.7 – I7.9 – 12.2009
Configuration data is available for system terminals only. It is stored in a parallel
Flash memory and saved during the AIMS backup.
Configuration data can be modified either using AIMS or directly from the system
terminal.
6. 1. 1. 5 System-specific data
The system-specific data (system ID, system type, sales channel, licence code, gen-
eration, DECT identification numbers, IP address of the Ethernet interface on the
mainboard) is stored on the EIM card (chip card). This data is not deleted by a first
start of the PBX, and remains available. It can be ported to a different PBX by replac-
ing the EIM card.
6. 1. 2 Updating configuration data
System configuration data can only be modified using AIMS (see also "System con-
figuration data", page 157).
Terminal configuration data can be modified using both AIMS and the system ter-
minal (see also "Terminal configuration data", page 157).
6. 1. 2. 1 Maintaining configuration data with AIMS
Maintaining configuration data with AIMS (Upload / Download, Backup / Restore)
is described in detail in AIMS help.
6. 1. 2. 2 Deleting terminal configuration data
To delete the system configuration data from a system terminal, delete the termi-
nal's user number from the numbering plan in the system configuration (Configu-
ration Manager) using the Delete key. All the data is then reset to its initialization
values.
The terminal configuration data of a single system terminal can be reset to the first-
start values in the Configuration Manager under 3_2_2 with the "Reset terminal
data" button.
To Next Page
Loading...
