Ascotel® IntelliGate® 150/300 as of I7.9
160 Operation and Maintenance
syd-0210/1.7 – I7.9 – 12.2009
"Options" pull-down menu
In menu itemOptions → Settings the default settings for the communication link
are configured. Please refer to the Help information to find out more about the in-
dividual parameters.
Monitor
The Upload Monitor is an Upload Manager function and is called up using Options
→ Monitor. The Upload Monitor is used to call up detailed information on the PBX
( e.g. hardware expansion, event messages, upload configuration). The Upload
Monitor is not available while a software upload is running.
6. 2. 1. 2 Standard upload
Loading a PBX with new system software takes places in several phases. The Up-
load Manager monitors the system software copying process from the PC to the
PBX. The PBX monitors the version transfer.
Sequence phases for the standard upload:
• Preparation phase:
The Upload Manager prepares the PBX for the transmission of the new system
software.
• Upload and backup phase:
The new system software is transmitted to the PBX in compressed form and
stored in the dedicated Flash memory on the Flash card. The previous system
software remains stored as a backup.
• Software update phase:
The current system software is replaced by the freshly loaded system software.
• Restart phase and version transfer:
The PBX is restarted automatically. The boot software starts the new system soft-
ware and runs a version transfer at the same time.
• Monitoring phase:
During the monitoring phase, the new system software is active, but the old re-
mains in the Flash memory. In this phase, the old system software can be reacti-
vated at any time with a "Rollback". When the monitoring phase is finished, the
old application is deleted.
To Next Page
Loading...
